Clevite MAHLE Connecting Rod Bearings CB-1643H Mitsubishi Evo 1-3 / 4-9 2.0/2.4 lt 16v with Standard Size

31.00 Χωρίς ΦΠΑ

 

  • Clevite® TriMetal™ engine bearings have been the industry standard since the first patent on the cast, copper, lead composition decades ago. These points are just a few of the advantages Clevite’s TriMetal™ engine bearings:
    • Seizure Resistance – Clevite TriMetal™ bearings have as much as 40% better seizure resistance than competitors’ engine bearings.
    • Load Capacity – Clevite TriMetal™ bearings can withstand over 60% higher loads for extended periods compared to competitor bearings.
    • Embedability & Conformability – The overlay on a TriMetal™ bearing offers a superior surface for forgiveness, offering additional protection that can be extremely beneficial in an engine that is poorly maintained.
    • Durability – Clevite TriMetal™ bearings not only exceed light vehicle OE durability requirements of 150,000 miles, they also exceed heavy vehicle OE durability requirements of 300,000 miles.
    • Even all tri-metal engine bearings are not the same. If you want the highest quality, strongest, and original TriMetal™ bearings, ask for Clevite Engine Bearings.
  • Contains one oil hole.
  • complete set for 4 rods.
  • Suitable for engines:
  • 4G63, 4G63T,4G64,

AVAILABLE ONLY ON REQUEST

Διαθέσιμο κατόπιν παραγγελίας

Κωδικός προϊόντος: CB-1643H Κατηγορίες: , , , , , , , Ετικέτες: , , , , ,

Περιγραφή

Sizes STD,.025, .25
Oil Clearance Standard
Half Type Upper & Lower
Material Tri-metal Hardened steel backs
Min Std Shaft Size 1.7709in / 44.981mm
Max Std Shaft Size 1.7715in / 44.996mm
Min Std Tunnel Size 1.8897in / 47.998mm
Max Std Tunnel Size 1.8905in / 48.019mm
Max Wall at Crown 0.0586in / 1.488mm
Max Overall Length 0.8307in / 21.10mm

Επιπλέον πληροφορίες

Κατασκευαστής

,

Ταιριάζει στις εξής μάρκες

Εφαρμογή

, ,

Ιδιότητες

H-Series bearings have a medium level of eccentricity, high crush, and rod bearings have a hardened steel back and thin overlay. Use H-Series bearings with crankshafts that have oversize fillets and where engines run in the medium to high RPM range. H-Series bearings should be used if contact patterns obtained with P-Series parts are too narrow. Contact patterns should ideally cover 2/3 to 3/4 of the bearing surface. If you aren\'t sure which type of performance bearing to start with, the H-Series bearing will be your best choice.

ΑΠΟΣΤΟΛΗ ΠΡΟΪΟΝΤΟΣ

Το προϊόν είναι άμεσα διαθέσιμο.

Εφαρμογές

Εφαρμογές προϊόντος δοκιμαστικό κείμενο.

Μπορεί επίσης να σας αρέσει…